|
[Sponsors] |
October 27, 2003, 23:42 |
modelling of conjugate heat transfer problem
|
#1 |
Guest
Posts: n/a
|
How to put boundary conditions for conduction+convection problem because sovler picks only one medium but heat flow is through metal and metal to air? any body may please guide?
|
|
October 28, 2003, 06:51 |
Re: modelling of conjugate heat transfer problem
|
#2 |
Guest
Posts: n/a
|
It is quite straightforward: in Gambit, define your metal grid similar as a fluid zone. In the fluid boundary conditions panel, set it to be a 'solid'.
After importing the mesh into Fluent, you can set the material type for this solid zone. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parametric runs and Optimization in ANSYS (Conjugate Heat Transfer Problem) | cp_jef | ANSYS | 0 | May 30, 2011 04:08 |
Modelling the heat transfer during compression and cooling of natural gas | pano | Main CFD Forum | 0 | December 10, 2010 15:53 |
Heat transfer problem | seojaho | CFX | 6 | May 6, 2010 00:32 |
Conjugate heat transfer problem with porous media | piko | Siemens | 1 | April 17, 2009 15:41 |
Heat Transfer Problem Help | JB | FLUENT | 2 | October 18, 2006 18:54 |