|
[Sponsors] |
How to update components of face boundary zone? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 13, 2003, 21:22 |
How to update components of face boundary zone?
|
#1 |
Guest
Posts: n/a
|
I am doing a laser cladding model, where mass flow is added in a moving molten pool (convection flow inside) on workpiece. I need to trace the growth of clad hump. If the workpiece top surface boundary can be updated at each time step, the face zone thread needs to be re-grouped. I think fluent does not allow to do so in UDF. So I am thinking to use multiphase model - consider a bigger domain which include workpiece and some null elements (air) above the workpiece. I can update the clad shap by some method. But how to add the boundary condition at the air/clad interface, such as laser power, convection and radiation heat transfer? Any suggestion is appreciated!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Internal walls of zero thickness | anger | OpenFOAM Meshing & Mesh Conversion | 23 | February 6, 2020 18:25 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Hydrostatic Pressure and Gravity | miliante | OpenFOAM Running, Solving & CFD | 132 | October 7, 2012 22:50 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |