|
[Sponsors] |
May 4, 2004, 11:15 |
transient
|
#1 |
Guest
Posts: n/a
|
What is transient, where i can set it?? fluent 5.2
|
|
May 5, 2004, 04:09 |
Re: transient
|
#2 |
Guest
Posts: n/a
|
Hi; Your question is very very very ... general!!! A transition case for each phenomena is a case between two known cases.
In CFD calculation transient, means an unsteady or time dependent flow field. To set unsteady calculation in fluent, you should set unsteady in solve pannel in model menue in define menue. Hope this help you ROOZBEH |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient conduction possible in fluent? | jlefevre76 | FLUENT | 2 | February 5, 2013 09:53 |
Laminar gas flow under slight suction - transient works but not steady | audrey | CFX | 1 | September 8, 2011 19:43 |
Best practice for transient simulations? | siw | CFX | 5 | October 30, 2010 05:45 |
transient simulation of a rotating rectangle | icesniffer | CFX | 1 | August 8, 2009 07:25 |
Transient vs Steady State | Adam | CFX | 1 | April 12, 2007 11:34 |