|
[Sponsors] |
June 15, 2004, 21:09 |
Spiece model problem!!
|
#1 |
Guest
Posts: n/a
|
Hi, I have some problem about execute Fluent code for heat transfer under combustion model.
The Physical domain is shown in the attached file.The inner tube is specified as combustion model, and the heat will transfer through the wall to the outer tube, the liquid water is used as coolant. The combustion model is OK, but I can not specified the material ¡Vwater in the Fluent solver. How should I do? |
|
June 16, 2004, 00:16 |
Re: Spiece model problem!!
|
#2 |
Guest
Posts: n/a
|
In Gambit specify the volume though which water flows as a FLUID CONTINUUM. Then in fluent specify this continuum as water.
Best Luck next time! |
|
June 16, 2004, 05:12 |
Re: Spiece model problem!!
|
#3 |
Guest
Posts: n/a
|
But, boundary condition panel fluid type can't not set material name in spiece model. How should I set the material name in fluid panel?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
k-w SST transitional model problem | shanon | ANSYS | 0 | September 21, 2010 09:00 |
Problem with turbulence model | akonduri | OpenFOAM | 2 | September 17, 2010 00:49 |
Turbulence model for mixing problem??? | nileshjrane | Main CFD Forum | 7 | September 14, 2010 04:57 |
Problem in Herschel-Bulkely model | emad | FLUENT | 0 | May 20, 2009 14:20 |
Non premixed model - combustion validation problem | David | FLUENT | 2 | October 24, 2003 10:06 |