|
[Sponsors] |
July 23, 2004, 01:08 |
Trouble in energy residuals
|
#1 |
Guest
Posts: n/a
|
I use surface injection model in DPM for injecting evaporable liquid in air in unsteadystate. Untill when the liquid had not come into contact with air, the convergence for each time step (50 micro seconds) was quick (some ten to twenty iterations). Since when the liquid has started entering the high velocity air stream, as seen in the particle tracks, the energy residual has remained stagnated at 1.12e-6 (convergence criteria set is 1e-6) even after 500 iterations.
I will be grateful if somebody enlightens me on this. Thanks, Prasad |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
energy in sonicFoam | joern | OpenFOAM Running, Solving & CFD | 1 | September 24, 2019 00:15 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
divergence in energy residuals | swarley | FLUENT | 2 | May 22, 2008 08:09 |
SIMPLE and energy equation convergence | Fabio | Main CFD Forum | 0 | June 1, 2007 06:06 |
Convergence - scaled vs unscaled residuals | HS | FLUENT | 1 | November 7, 2005 05:45 |