|
[Sponsors] |
November 16, 2004, 08:21 |
Partikel Combustion
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I would like to simualte a combustion of wood partikels: There are two fractions, the char fraction (20%) and the volatile fraction (80 %). In the fluent tutorial, I only can find an example where I can declare the C,H,O,N-mass fraction. But I want to declare chemical reactions on molecular level. But this is only possible when I change the "Species Model" from "Non-premixed combustion" to "Species transport" (Volumetric). But in that case, I can't declare a devolatilizing mixture in the injection panel, only one single species. The same problem occurs with the "Oxidizing species" and "Product Species" - there will be more than one product, too. Any suggestions ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
hydrocarbon gases + Boron particle combustion | nileshjrane | OpenFOAM | 1 | December 13, 2010 06:20 |
can alternate combustion model by UDF? | Han Xingsi | FLUENT | 0 | September 1, 2008 02:08 |
Hydrogen Air combustion in a combustion chamber | popi | CFX | 7 | July 11, 2007 18:40 |
Need Similar Combustion Tutorial as my model | Arnab | Siemens | 0 | May 24, 2005 18:23 |