CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

Meshing a 3d conical diffuser

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   June 20, 2005, 10:54
Default Meshing a 3d conical diffuser
  #1
david
Guest
 
Posts: n/a
Hi all, I would like some advice on the meshning of a 3d conical diffuser. Consider this: I meshed 3 volumes corresponding to the small diameter pipe (inlet), a second volume for the diffusing section and a third volume for the larger diameter (outlet). I have split the walls of each of these 3 volumes in 4 to be able to map the end cap faces of the diffuser to be able to use the map scheme when comes the time to mesh the volumes. So far so good.

My specific problem is that I am having using the boundary layers (b.l.). For instance when I attach a b.l. on the inside face of one volume (corresponding to inner wall of pipe) I cannot attach a b.l. on the adjacent inner face because of an overlap in b.l. A typical message ressembles to this:

ERROR Boundary layer b_layer.1 already attached to the edge.9:face.6 pair. This must be removed befor attaching other boundary layers.

A second issue is that due to high aspect ratio I would like to be able to modify the length of meshed volume in the axial direction (along the pipe's length). How can this be done in 3d.

Could someone give me some advice on these 2 problems?

Best Ragards, David
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ICEM] Hexa meshing of impeller and diffuser assembly Nitin Dewangan ANSYS Meshing & Geometry 14 September 13, 2016 09:41
Problems of Icem meshing about Conical Forebody raja2010 ANSYS Meshing & Geometry 2 December 6, 2010 10:20
conical diffuser and turbulence model Markus Main CFD Forum 0 February 24, 2008 08:34
How to do boundary layer meshing of a 3D diffuser Durgendra FLUENT 2 June 27, 2006 07:46
conical diffuser design Seung Yi Main CFD Forum 1 August 22, 2000 13:29


All times are GMT -4. The time now is 12:42.