|July 6, 2005, 11:10||
velocity field divergence?
I've recently ran a simulation which seemed to work fine. Now, after making a slightly smaller version of the model, it won't run and i keep getting the following message:
Updating solution at time level N... Error: Too many (0) VOF sub-timesteps. The velocity field is probably diverging. Please check the solution, and reduce the time-step if necessary.
I presumed this meant that i had to change the time step in the 'iterate' section, but this doesn't seem to work??? I've double checked all my parameters and they are the same as the last simulation i preformed. Could this be a mesh problem?
Thanks in advance for any advice!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Moving mesh||Niklas Wikstrom (Wikstrom)||OpenFOAM Running, Solving & CFD||122||June 15, 2014 06:20|
|real velocity field from energy spectrum||Angel||Main CFD Forum||7||December 13, 2013 21:40|
|Editing chtMultiRegionFoam to not solve velocity field||tH3f0rC3||OpenFOAM||16||April 20, 2011 10:53|
|fixed velocity field||Glen||CFX||3||August 28, 2006 12:17|
|Copying velocity field from one bc to another||jorllam||CFX||4||June 30, 2006 02:08|