|
[Sponsors] |
November 7, 2004, 14:06 |
turbo topology
|
#1 |
Guest
Posts: n/a
|
i have 3D model of a rotor that i made in PROE.when i exported it to FLUENT after meshing in GAMBIT i cudnt define the turbo topolgy it said "not valid topology",not defined.I had already defined boudary conditions in GAMBIT like inlet,outlet,casing,hub and blades. can anyone help-its urgent thank you
|
|
November 7, 2004, 23:19 |
Re: turbo topology
|
#2 |
Guest
Posts: n/a
|
did u make periodic bc in gambit?
|
|
November 8, 2004, 01:59 |
Re: turbo topology
|
#3 |
Guest
Posts: n/a
|
no i didnt make periodic bc in gambit.all i have is 1.casing-wall 2.hub-wall 3.blades(22)-wall 4.inlet-velocity inlet 5.outlet-outflow which one do i make periodic?.also i didnt use any of the turbo options in gambit. thank you
|
|
November 9, 2004, 01:07 |
Re: turbo topology
|
#4 |
Guest
Posts: n/a
|
please consider repeating or cyclic sector geometry for periodicity. bye
|
|
May 23, 2013, 20:05 |
shroud tip modeling in fluent
|
#5 |
New Member
|
how can i define the shroud tip in fluent >>>is it periodic of internal
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Building topology command script files | Anorky | ANSYS Meshing & Geometry | 8 | January 11, 2010 07:25 |
Gambit turbo problem. | sujan.dasmahapatra | FLUENT | 0 | December 20, 2009 05:21 |
ICEM topology | Igor-a | CFX | 0 | July 24, 2008 07:05 |
turbo topology in gambit and fluent | RAMESH K | FLUENT | 0 | May 31, 2006 02:52 |
How to setup up correct Turbo Topology | Tobias | FLUENT | 0 | October 19, 2005 05:42 |