 |
 |
 |
|
|
|
[Sponsors] | ||||
October 11, 2005, 03:23
|
Meshing in narrow regions
|
#1 |
|
Guest
Posts: n/a
|
In a centrifugal pump, the gap between casing and impellor is very small (about 0.004 inch). In that location, how to mesh by providing atleast 5 or 6 elements? Is it possible to mesh for such small gaps in a big domain?
looking for a kind response regards satyamu |
|
|
||
|
October 11, 2005, 03:57
|
Re: Meshing in narrow regions
|
#2 |
|
Guest
Posts: n/a
|
You can mesh the small region first (at least the small surfaces) and then you can apply size function keeping the meshed surface as source face and mesh entire volume.
|
|
|
|
||
|
October 11, 2005, 05:12
|
Re: Meshing in narrow regions
|
#3 |
|
Guest
Posts: n/a
|
can u plz mail to this id.JOLIUS@KUKTEM.EDU.MY he has meshed in narrow regions in this model ie cyclone seperator
thnk u falak |
|
|
|
||
|
October 11, 2005, 19:11
|
Re: Meshing in narrow regions
|
#4 |
|
Guest
Posts: n/a
|
I have a doubt on this! Are N-S equations able to capture the flow physics in such a small region? Is continuum assumption valid in this domain?
thanx Rajesh |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Creating mesh regions in ANYS Meshing | Tarjei | ANSYS Meshing & Geometry | 0 | February 28, 2011 12:32 |
| [GAMBIT] Meshing multiple 3D regions | gascortado | ANSYS Meshing & Geometry | 2 | February 7, 2011 12:12 |
| Meshing Regions Problem | m.nichols19 | OpenFOAM | 2 | January 12, 2011 02:09 |
| [Other] Importing regions from 3rd party meshing programms | suitup | OpenFOAM Meshing & Mesh Conversion | 1 | November 10, 2009 09:40 |
| Meshing in narrow regions | Satyam | CFX | 7 | October 27, 2005 15:17 |
Linear Mode
