|
[Sponsors] |
December 4, 2005, 08:19 |
automatic surface creation
|
#1 |
Guest
Posts: n/a
|
I have 2d mesh with 500 points in axial direction and 200 radial direction.
Now I would like to plot Temperature over all the radial profile(200 points) on every x that means(500 points). Now everybody agress it is difficult create 500 surface by hand. so what I tried is to interpolate the Temeparetaure field on to some other mesh but in my steady since the errors in interpolation I could not satisfactory results. I would like to know is it possible to make surface creation automatic either by using UDF or someother methods. Anybody help me please. Your help is much apreciated. Q |
|
December 5, 2005, 01:23 |
Re: automatic surface creation
|
#2 |
Guest
Posts: n/a
|
use udf create a boundary profile but your discription is not clear bye
|
|
December 5, 2005, 04:17 |
Re: automatic surface creation
|
#3 |
Guest
Posts: n/a
|
Could you tell me atleast what is not clear. I want to get the radial profiles of the Temp at each x nodes.
Q |
|
December 5, 2005, 04:31 |
Re: automatic surface creation
|
#4 |
Guest
Posts: n/a
|
Ok use Define profile in UDF then interprted your code bye
|
|
December 5, 2005, 10:07 |
Re: automatic surface creation
|
#5 |
Guest
Posts: n/a
|
hello what you are talking about can be done when u are starting the calculations what I asking is about postprocessing stage. If you dont know please refrain from asnwering it. Q
|
|
December 6, 2005, 01:42 |
Re: automatic surface creation
|
#6 |
Guest
Posts: n/a
|
Ok I apologize. I dont answer any question of you goodluck
|
|
December 6, 2005, 02:57 |
Re: automatic surface creation
|
#7 |
Guest
Posts: n/a
|
i think you shall be able to create them in journal file and export the results on them as you need.
I guess this is easiest way of doing it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
problem with surface creation in ICEM from multiple curves | dialolema | ANSYS Meshing & Geometry | 2 | October 27, 2014 13:14 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |