|January 3, 2006, 04:18||
error while iteration
I have met with some problems in using fluent to simulate the flow of a liquid with an air bubble in a square channel.
I am using VOF model to simulate this flow.
The problem I met with is that whenever I input a value for the surface tension between the liquid and the gas, I will receive an error message while iterating.
Error message: "Too many sub time step. The velocity field is probably diverging……..Reduce time step"
I hope you all can give me some advice regarding this problem
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to increase "Newton Pressure Iteration Limit"||kus||CFX||9||April 21, 2013 01:54|
|snappyHexMesh aborting||Tobi||OpenFOAM Native Meshers: snappyHexMesh and Others||0||November 10, 2010 04:23|
|Parallel runs slower with MTU=9000 than MTU=1500||Javier Larrondo||FLUENT||0||October 28, 2007 23:30|
|Creating, loop or iteration using expression edito||Jan||CFX||3||July 28, 2003 11:01|
|Heat exchanger problem||chiseung||FLUENT||16||October 20, 2001 04:36|