 |
 |
 |
|
|
|
[Sponsors] | ||||
February 21, 2006, 18:13
|
Can't figure which cell particle is going to -- AB
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
I'd never seen this msg."Can't figure which cell particle is going to -- ABORT" .Anyone have any ideas what's the reason? I injected fuel and moisture on the same (plane+bounded) surface.I'd run the same method like this before but the difference is at first case, i've created the surface in the gambit and set it as a wall in BC. Then, i injected the fuel and moisture from the plane. I would like to hear any advice/suggestion.Thanks in advance. -Am- |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cells with t below lower limit | Purushothama | CD-adapco | 2 | May 31, 2010 21:58 |
| Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 2 | July 15, 2005 04:15 |
| Warning 097- | AB | CD-adapco | 6 | November 15, 2004 04:41 |
| Can't figure which cell particle is going to? | Easycad | FLUENT | 4 | November 13, 2003 07:18 |
| Can't figure which cell particle is going to | rookie | FLUENT | 2 | June 12, 2003 20:35 |
Linear Mode
