|
[Sponsors] |
February 22, 2006, 07:30 |
Granular starting point not at a boundary
|
#1 |
Guest
Posts: n/a
|
Hi, I am using the Eurlerian method for modelling gas flow through a flowline. I have a gas phase flowing from the inlet, and at a certain point along the flowline (i.e. not at a boundary) i want a granular phase to start flowing. Does anyone know how to add a phase to a flow at a point other than a boundary???
Thanks in advance, Mike |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
point source boundary | hydroking | OpenFOAM | 0 | April 19, 2009 10:39 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Boundary condition for point? | J.W.Ryu | FLUENT | 5 | April 6, 2003 23:45 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |