 |
 |
 |
|
|
|
[Sponsors] | ||||
June 26, 2006, 07:23
|
Case Reading in Fluent
|
#1 |
|
Guest
Posts: n/a
|
Hi,
When I want to read my mesh file with Fluent, it gives me this error message : #Error: no cells in zone, id = 0, ind1 = 1, indn = 0Reading Cells: failed while reading section 12. Clearing partially read grid.# How can I find which zone is creating problems and what kind of problem is this? Thank you for answering ! |
|
|
||
|
June 29, 2006, 02:42
|
Re: Case Reading in Fluent
|
#2 |
|
Guest
Posts: n/a
|
Hi
I think the problem in your mesh file, hence you may make another mesh file by Gambit. Make sure that this file is correct, then open it by Fluent. It will be good, I guess. Rola |
|
|
|
||
|
July 4, 2006, 03:47
|
Re: Case Reading in Fluent
|
#3 |
|
Guest
Posts: n/a
|
Thank you for the advice.
In fact my mesh wasn't that good, I had a few EquiAngle Skews superior to 0.9. Youenn. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent jobs through pbs | ibnkureshi | FLUENT | 5 | June 9, 2011 13:43 |
| residual spikes in fluent for airfoil case | josip76 | ANSYS | 0 | May 24, 2011 19:30 |
| How to read or write case by commands during simulation with Fluent | lzgwhy | FLUENT | 4 | April 20, 2011 22:02 |
| Does anyone has the case & dat file for tutorial of ansys fluent 12 | zhang.limin | Main CFD Forum | 0 | March 2, 2010 13:03 |
| Fluent case file into Gambit | Eric R. | FLUENT | 7 | July 17, 2002 14:11 |
Linear Mode
