|
[Sponsors] |
July 17, 2006, 07:52 |
Gridgen to Tgrid export
|
#1 |
Guest
Posts: n/a
|
I want to export a surface mesh from gridgen to Tgrid. The STL format works, but all surfaces are imported in Tgrid as a single zone. I need separate zones. How can I do this?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Export mesh to Gridgen | ali987 | ANSYS Meshing & Geometry | 2 | January 2, 2010 12:20 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Gridgen export problem with memory allocation? | july | Pointwise & Gridgen | 5 | July 21, 2008 20:29 |
Gridgen Export to Fluent5/6 failure due to memory | ND | Pointwise & Gridgen | 2 | September 1, 2007 10:28 |
Gridgen export | Marinos Manolesos | FLUENT | 4 | April 29, 2006 13:42 |