|
[Sponsors] |
|
September 15, 2006, 08:51 |
Using Fluent to simulate DBD lamp
|
#1 |
Guest
Posts: n/a
|
Hi all,
I just want to know that does someone use Fluent software to simulate electrical breakdown (plasma) in a pulsed dielectric barrier discharge (DBD lamp). It would be very appreciated that if someone could show this experience or give some information about which CFD sofeware can model DBD lamp. Thanks in advance, Mark |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Abaqus - Fluent Coupling WITHOUT MPCCI | s.mishra | FLUENT | 1 | April 5, 2016 06:47 |
How Fluent simulate lake flow under wind drag? | billowboy | FLUENT | 2 | August 13, 2009 04:49 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |
Could I simulate the HEAT PIPE use FLUENT | Saturn | FLUENT | 1 | December 6, 2004 05:00 |
help:how can I simulate a flame in the fluent? | amir ghavidel | FLUENT | 0 | May 15, 2002 04:28 |