|
[Sponsors] |
August 23, 2006, 03:52 |
Reversed Flow on Iterate
|
#1 |
Guest
Posts: n/a
|
I was ran the model more than 50 time,all problem seen reversed flow condition,i also try use pressure inlet as atmospheric pressure and oulet is o at the gauge pressure,but the problem is same,reversed flow.Hopes anybody can help?My Case study is simulate scavenging process on two-stroke engine.
|
|
August 24, 2006, 03:21 |
Re: Reversed Flow on Iterate
|
#2 |
Guest
Posts: n/a
|
Where you are getting this reversed flow? If it is near to inlet or outlet, just extend the domain of control volume.
|
|
September 16, 2006, 02:39 |
Re: Reversed Flow on Iterate
|
#3 |
Guest
Posts: n/a
|
how to make extend the domain of control volume?
|
|
October 4, 2006, 10:58 |
Re: Reversed Flow on Iterate
|
#4 |
Guest
Posts: n/a
|
make a geometry at least 100% greater than ur present geometry..
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reversed flow | free | FLUENT | 4 | February 27, 2014 01:56 |
reversed flow during RNG in turbulence-k epsilon | Suman Kandula | FLUENT | 4 | April 2, 2012 07:12 |
Reversed flow...>>>Please HELP...! | sushii | FLUENT | 14 | October 29, 2007 04:27 |
reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 13:11 |
reversed flow | Sastry | FLUENT | 5 | March 22, 2007 08:05 |