 |
 |
 |
|
|
|
[Sponsors] | ||||
November 11, 2006, 13:10
|
mesh size - number of nodes
|
#1 |
|
Guest
Posts: n/a
|
hey i want to simulate a compressor rotor. i have to solve in two way. one actual model and 2nd scale down model by 100
now my question is that in CFD wiki it says a good mesh with wall function should be 400,000 cells , so i wanna know that should i use 400,000 cells for both models (actual and scale down) if yes why and if no then also why \????????? regards |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
| critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
| Interpolation (Number of mapped nodes) | Sam | CFX | 3 | January 6, 2008 19:51 |
Linear Mode
