|February 19, 2007, 00:11||
Powder melting/solidification deposition process
I am setting up a model which simulate this process: a heating source on a solid metal surface to create a melting pool, then same metal powder will be injected in the melting pool, and this whole thing is put in an argon enviroment.
I want to get the interface between the liquid metal and solid metal, the interface between the liquid metal and argon, and I want to see the deposition of the powder, that the metal powder is also melted and mass transfer into the melting pool.
I used VOF+Injection+Melting/Solidification model, it won't work well.
What other method can I choose? or Is there any specific detail I should pay attention to?
Thank you vey much.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic mesh help - Deposition process||TDi||FLUENT||1||February 13, 2013 11:55|
|Powder Flow||solimcfd||FLUENT||0||August 22, 2010 17:58|
|HX fouling via polymer powder deposit||thomas||FLUENT||0||April 29, 2005 11:56|
|HX fouling via polymer powder deposit||thomas||CFX||0||April 29, 2005 11:56|
|powder injection||O.B||FLUENT||0||January 2, 2005 05:31|