|
[Sponsors] |
April 3, 2007, 08:40 |
Exit from UDF DEFINE_DPM_LAW
|
#1 |
Guest
Posts: n/a
|
Hi, I need to correct my UDF (DEFINE_DPM_LAW) for terminating the calculation of the discrete particle diameter when a particle reaches a certain position in domain:
I try for example: if( P_POS(P)[1] >= 1.5) { PATH_END;} ... or PATH_STOP, PATH_ABORT etc. All those commands cause skipping actualization of the particle diameter in the calculation beyond the geometrical limit i set but still carry on creation the pparticle track as the particle leaves this region. How can i completely terminate the particle track in certain region of the domain? Thanks a lot for your answer. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF parallel error: chip-exec: function not found????? | shankara.2 | Fluent UDF and Scheme Programming | 1 | January 16, 2012 22:14 |
Accelerating pre and checking the mfr at exit how to hook udf to Pressure inlet(BC) | kokoory | Fluent UDF and Scheme Programming | 0 | August 17, 2011 08:20 |
UDF for transient pressure inlet, mass flow check at nozzle exit and volumetric heat | kokoory | FLUENT | 0 | August 17, 2011 02:07 |
UDF, UDF, UDF, UDF | Luc SEMINEL | Main CFD Forum | 0 | November 25, 2002 04:01 |