|
[Sponsors] |
April 15, 2007, 16:34 |
How to defient the B.C at the Diaphragm
|
#1 |
Guest
Posts: n/a
|
Hi, I have a problem with the B.C set up. I have a diaphragm that seperates the high pressure region and low pressure region. After the high pressure reaches some critical value, the diaphragm breaks. How to define the B.C on the diaphragm?
I want to define the diaphragm as wall condition before reaching the critical pressure, and let the wall condition at diaphragm disappear after the diaphragm breaks. How to set up this B.C? Any help is appreciated. Bob |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Confusion between 'non-slip' and 'slip' B.C | jinwon park | Main CFD Forum | 7 | March 6, 2008 04:56 |
Urgent! Help on UDF to set B.C. of 3rd type | Ray Hong | FLUENT | 0 | December 28, 2005 19:35 |
How to set B.C. of the 2nd or 3rd type in UDS? | Ray Hong | FLUENT | 0 | December 28, 2005 06:03 |
how to setup a diaphragm | RAN | FLUENT | 5 | November 13, 2002 09:33 |
Non-Reflecting B.C. in NSC2KE | Zou Chu | Main CFD Forum | 2 | May 27, 1999 21:26 |