 |
 |
 |
|
|
|
[Sponsors] | ||||
July 27, 2007, 06:11
|
gambit *.NEU* file in write a cfd code
|
#1 |
|
Guest
Posts: n/a
|
hi all. i want write a cfd code. i want to bring mesh geometry of a software that can produce mesh . please tell me that can gambit *.NEU* file help me? if no please help me. thanks alot.
|
|
|
||
|
July 27, 2007, 07:02
|
Re: gambit *.NEU* file in write a cfd code
|
#2 |
|
Guest
Posts: n/a
|
||
|
|
||
|
July 27, 2007, 07:48
|
Re: gambit *.NEU* file in write a cfd code *NM*
|
#3 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
July 28, 2007, 08:00
|
Re: gambit *.NEU* file in write a cfd code
|
#4 |
|
Guest
Posts: n/a
|
Yes, you could use the Gambit neutral file for your CFD code with a few extra works.
You have in the neutral file: - a list of vertex coordinates; - a list of nodes defining a cell; - the nodes that defining your boundary. In principle you need to generate a list edges/faces from the Gambit output. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Linear Mode
