 |
 |
 |
|
|
|
[Sponsors] | ||||
August 17, 2007, 11:28
|
porous jump
|
#1 |
|
Guest
Posts: n/a
|
Hi everyone,
Im a new user of fluent and I am trying to model a 2d pipe leakage. The pipe is situated into sand and above (and below) the sand there is plain soil. I have used GAMBIT to produce the grid and defined tha boundary condition of the line separating the two materials as porous jump. When I try to read the mesh file in FLUENT i get the error message: "Cannot change porous_jump to porous-jump because there is only one adjacent cell thread." Any ideas on what I need to change? Thanks a lot, Louisa |
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How can I define different zones in ICEM? | llrr | ANSYS Meshing & Geometry | 14 | February 12, 2017 13:44 |
| [Commercial meshers] Porous Jump creation problem | mulfal | OpenFOAM Meshing & Mesh Conversion | 4 | December 9, 2013 11:59 |
| Porous jump in urban environment | samygero | FLUENT | 0 | February 14, 2011 18:26 |
| Porous Jump | Naresh | FLUENT | 0 | April 25, 2007 15:36 |
| Testing the integrity of POROUS media and por jump | Azman | FLUENT | 0 | July 31, 2006 11:11 |
Threaded Mode
