|
[Sponsors] |
September 4, 2013, 03:01 |
time steps count
|
#1 |
Member
|
Hi everybody
im writing UDF using DEFINE_CG_MOTION I have to make at the end of calculation low pass filter of the results and i want to include the filter in the aforementioned UDF. In these case i need to know when is the end of calculation. So the question is is there possibility to get time step count to include it in UDF |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiple floating objects | CKH | OpenFOAM Running, Solving & CFD | 14 | February 20, 2019 09:08 |
AMI interDyMFoam for mixer nu problem | danny123 | OpenFOAM Programming & Development | 8 | September 6, 2013 02:34 |
mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
same geometry,structured and unstructured mesh,different behaviour. | sharonyue | OpenFOAM Running, Solving & CFD | 13 | January 2, 2013 22:40 |
calculation diverge after continue to run | zhajingjing | OpenFOAM | 0 | April 28, 2010 04:35 |