|
[Sponsors] |
wall emissivity for radiation problem: emitter is also receiving when it shouldn't |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 10, 2008, 09:24 |
wall emissivity for radiation problem: emitter is also receiving when it shouldn't
|
#1 |
Guest
Posts: n/a
|
Dear all,
I'm simulating a DO radiation model. It is simple, I just put a ball inside a cubic, set the ball temperature to 1000K and internal emissivity to 1. The cubic surfaces have a 0K temperature and internal emissivity also as 1. So according to the rules, all the radiation by the ball inside will be absorbed by the cubic surfaces. So the ball should only have a radiation out. However, after the simulation, I found ball also receive radiations. Not sure where the origin is. And as I changed the ball temperature, I found the received radiation is proportional to the radiation out. Could anyone help me out? Thanks ahead, Young |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
Moving Wall Problem | dreamchaser | CFX | 3 | October 15, 2014 17:10 |
Rotating Wall Problem Not Working | dreamchaser | CFX | 4 | September 29, 2014 10:09 |
Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 22:22 |
moving wall BC problem | Sourabh | Main CFD Forum | 1 | August 8, 2006 07:47 |