|
[Sponsors] |
November 29, 2008, 18:33 |
Including Gravity Component
|
#1 |
Guest
Posts: n/a
|
I am modeling a boat moving through water. Because I am not very experienced with Fluent, I simplified the modeling and had the boat stationary with the water having velocity. I am looking at the y component of the water and would like to show the static pressure changing with the height of water. I assume I would need to use the gravity component in Fluent but when I check it under the Operating Conditions panel, there is no change in results.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Including a new utility in OF 13 | alondono | OpenFOAM Running, Solving & CFD | 7 | April 11, 2008 09:17 |
Gravity component and inlet velocity | Vidya | FLUENT | 8 | July 31, 2006 08:28 |
gravity-table.scm scheme file for trans gravity | Shankar | FLUENT | 0 | May 31, 2006 04:30 |
including gravity in 1D model | Amir Filipovic | Main CFD Forum | 0 | November 18, 2003 15:23 |
Including gravity in calculations!!! | gilberto | CFX | 26 | October 15, 2001 20:55 |