|May 27, 2009, 23:09||
Question: heat conduction in multiphase solid
Join Date: May 2009
Posts: 4Rep Power: 8
I want to simulate steady state heat conduction through a multiphase solid, e.g., two separated phases and each phase has a specific thermal conductivity.
Can fluent solve this problem?
I will know the detailed location for each phase. Then how can I specify the location-dependent thermal conductivity?
It seems to be a simple problem, but I am just a beginner and cannot figure out the approach. Your response will be greatly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|heat conduction in solid - mismatch to exp. res.||Ralf Schmidt||FLUENT||1||December 9, 2008 09:34|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Heat conduction through solid rib in periodic duct||Dieter Fauconnier||FLUENT||0||October 7, 2004 08:22|
|Heat flux question?||Mark||Main CFD Forum||0||February 13, 2004 10:03|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|