|
[Sponsors] |
June 19, 2009, 10:41 |
Operating conditions
|
#1 |
New Member
Join Date: Jun 2009
Posts: 1
Rep Power: 0 |
Hi everyone,
I'm simulating a piping placed on the seabed Oil flows inside the pipe which is surrounded by water. The operating conditions are really different between the sea and the oil. Here is the question: Is it possible to use different operating conditions in different zones? (oil_zone; sea_zone) I'd like to set up different operating conditions in the two zones because I have convergence problems that are related to this issue (well, I think so...). See below: #Divengence detected in AMG solver: pressure coupled -> Increasing relaxation sweeps! Primitive error at node 1: Divergence detected in AMG solver Primitive error at node 2: Divergence detected in AMG solver Primitive error at node 0: Divergence detected in AMG solver Error: Compute node encountered error Error Object: #finvalid command [#] Thank you in advance Cheers |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Grid scaling & Operating conditions | shankara.2 | FLUENT | 0 | May 28, 2009 13:56 |
Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 06:25 |
operating conditions | Davide | FLUENT | 1 | October 26, 2003 19:07 |
Operating Conditions | Pravir Kumar Rai | FLUENT | 1 | April 9, 2002 03:13 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |