|
[Sponsors] |
September 12, 2009, 03:35 |
wall adhesion
|
#1 |
New Member
Eric
Join Date: Apr 2009
Posts: 23
Rep Power: 17 |
in fluent,when we activate wall adhesion in phase interanction ,we can define the contact angle .
my question is the contact angel should be the angel between phases,can we define the contact angle(wetting angel )between phase and wall? i am working on the oil carrying the residual water in inclined pipe.in the experiment,the water is distributed alone the inclined pipe(upward) at certain velocity of the oil.but the CFD result is that the water could be taken away only the time is long enough..so i think it might be related with different wetting angles of the phases(oil and watet) with wall. can you give me some ideas! regards duaiduaihu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
angle for wall adhesion in two phase flow | Al-jasim | FLUENT | 0 | August 18, 2007 10:04 |
Wall adhesion | Rucy | FLUENT | 0 | November 26, 2005 22:00 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |