|September 15, 2009, 23:02||
Boundary layer is necessary or not?
Join Date: Sep 2009
Posts: 3Rep Power: 8
By the past articals, it said that the boundary layer in suction section is more important...
Is the boundary layer should be set in mesh file when I simulate in a complex profile?
What is the different in the results without using boundary layer?
|September 16, 2009, 01:48||
Join Date: Mar 2009
Posts: 3,080Rep Power: 31
it depends on what you want to compute.
if BL effects are to be investigate, then you may use BL for best approach.
You can compute your model with and without BL, you will see the difference, or not. Once again it depends on the your model.
In memory of my friend Hervé: CFD engineer & freerider
|Thread||Thread Starter||Forum||Replies||Last Post|
|Default Faces on Boundary Layer||axel||Open Source Meshers: Gmsh, Netgen, CGNS, ...||8||February 17, 2011 08:47|
|Adapt mesh without modifying boundary layer cells?||Freeman||FLUENT||0||February 22, 2009 15:11|
|3D Boundary Layer||Mario||FLUENT||0||February 17, 2009 04:40|
|Adding layer to cyclic boundary||Chris P||CD-adapco||3||November 15, 2004 22:17|
|boundary layer simulation : basic issues||amol palekar||Main CFD Forum||0||July 27, 2004 18:22|