[p52sarup]

Hello,

I need to perform an analisis transient where the pressure-inlet changes over time according to the following table:

Time (s)--------Pressure (Pa)
0-----------------25000
2-----------------50000
3-----------------75000
4-----------------100000
5-----------------125000
6-----------------150000
7-----------------175000
8-----------------200000
9-----------------25000
10----------------100000

the flux in outlet is constant.

I make a follow file .prof

((trans_pressure transient 10 0)
(time 0 1 2 3 4 5 6 7 8 9)
(pressure 0 25000 50000 100000 125000 150000 175000 200000 25000 100000))

after, in boundury condition inlet, i can to select, "trans_pressure time" or "trans_pressure pressure" why??

is it correct form??





thank