 |
 |
 |
|
|
|
[Sponsors] | ||||
December 11, 2020, 01:25
|
Ansys Fluid Meshing
|
#1 |
|
New Member
Prakhar Yadav
Join Date: Dec 2020
Posts: 8
Rep Power: 5  |
Hello Everyone,
I am trying to simulate a 3D vertical axis wind turbine using Ansys Fluid Meshing. When I am trying to create a Surface mesh it gives me a warning, ----Warning---- 2 objects/parts were detected after surface meshing. This topology is not supported Please help me understand where is the problem??? |
|
|
|
|
|
December 11, 2020, 06:03
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
never have seen this error before but may be you have some points or lines which are not the part of geometry?
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
|
December 12, 2020, 09:24
|
|
#3 |
|
New Member
Prakhar Yadav
Join Date: Dec 2020
Posts: 8
Rep Power: 5 |
thank you for the response
|
|
|
|
|
|
 |
| Tags |
| ansys fluent 19.2, fluent meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Mixed Order Meshing in ANSYS Meshing | oozcan | ANSYS Meshing & Geometry | 1 | August 1, 2020 06:48 |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
| [ANSYS Meshing] Can start ANSYS meshing only one time on ubuntu 16.04 | Touré | ANSYS Meshing & Geometry | 2 | September 26, 2017 05:41 |
| Meshing on hpc using ansys mesh | AS_Aero | CFX | 13 | April 3, 2017 19:05 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
1Likes
Linear Mode
