HELP!a problem when starting the unsteady iteration in Fluent

usst139 · January 19, 2010, 08:56

I have a problem when starting the unsteady iteration in Fluent,and it said——"warning:non-positive volumes exist.
Error:divergence detected in AMG solver

ressure correction
Error object

)

I guess something wrong with my original grid in Gambit?
hELP ME!THANK YOU!

radix · January 20, 2010, 12:41

You might to reconsider your meshing result from GAMBIT. Check your mesh result. Have a look on your right corner of your GAMBIT window to this. The 'non-positive volume' exist due to the highly-generated skewness.
As for the divergence problem,you can prevent this by setting your 'under-relaxation factor'. Make it smaller.
Hope this short reply would solve your problems.

Regards,
Raditya

usst139 · January 21, 2010, 01:37

Thank you for your kind advice,Raditya

Yes,the blade in my model has a very high skewness,so I 'm trying to use the Boundary Layer or Sizefunction to make a better mesh

January 19, 2010, 08:56	HELP!a problem when starting the unsteady iteration in Fluent	#1
usst139 New Member xuusst Join Date: Jan 2010 Posts: 4 Rep Power: 16	I have a problem when starting the unsteady iteration in Fluent,and it said——"warning:non-positive volumes exist. Error:divergence detected in AMG solver ressure correction Error object) I guess something wrong with my original grid in Gambit? hELP ME!THANK YOU!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with Fluent Parallel	DarrenC	ANSYS	0	October 27, 2009 05:38
Fluent dpm (unsteady) problem! Urgent!	Aris Nikolopoulos	FLUENT	0	January 17, 2008 07:54
Problem in Tutorial problem of fluent	Phanindra	FLUENT	5	April 17, 2007 09:57
Problem in Reporting Unsteady Particle Fates	Nelson	FLUENT	0	August 23, 2006 20:24
starting fluent under freeBSD4.9	Herakles	FLUENT	0	June 2, 2004 09:05

January 20, 2010, 12:41		#2
radix New Member Raditya Wiranegara Join Date: Aug 2009 Location: United Kingdom Posts: 22 Rep Power: 16	You might to reconsider your meshing result from GAMBIT. Check your mesh result. Have a look on your right corner of your GAMBIT window to this. The 'non-positive volume' exist due to the highly-generated skewness. As for the divergence problem,you can prevent this by setting your 'under-relaxation factor'. Make it smaller. Hope this short reply would solve your problems. Regards, Raditya

January 21, 2010, 01:37		#3
usst139 New Member xuusst Join Date: Jan 2010 Posts: 4 Rep Power: 16	Thank you for your kind advice,Raditya Yes,the blade in my model has a very high skewness,so I 'm trying to use the Boundary Layer or Sizefunction to make a better mesh