|
[Sponsors] |
May 26, 2010, 11:06 |
combustion
|
#1 |
New Member
santhosh
Join Date: May 2010
Posts: 7
Rep Power: 15 |
hi everyone
Am a student. My project is simulating 3-D combustion modelling of gas turbune combustor. i had run the steady state continuous phasefirst. Then injested fuel by creating a unsteady state DPM phase injection. but my model is not combusting. the fuel am using is kerosene-air. i need to know if i should use the spcies transport model or the non-premixed combustion model of simulating combustion. Since am doing a DPM phase, am not sure which one to use. can someone give me some advice on this? thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hydrogen Air combustion in a combustion chamber | popi | CFX | 7 | July 11, 2007 18:40 |
Need Similar Combustion Tutorial as my model | Arnab | Siemens | 0 | May 24, 2005 18:23 |
Multiresolution + Turbulence + Combustion | Raul | Siemens | 0 | March 18, 2005 07:56 |
Multiresolution + Turbulence + Combustion | Raul | CFX | 0 | March 18, 2005 07:53 |
Multiresolution + Turbulence + Combustion | Raul | Main CFD Forum | 0 | March 18, 2005 07:53 |