|May 26, 2010, 12:06||
Join Date: May 2010
Posts: 7Rep Power: 5
Am a student. My project is simulating 3-D combustion modelling of gas turbune combustor.
i had run the steady state continuous phasefirst. Then injested fuel by creating a unsteady state DPM phase injection.
but my model is not combusting. the fuel am using is kerosene-air.
i need to know if i should use the spcies transport model or the non-premixed combustion model of simulating combustion. Since am doing a DPM phase, am not sure which one to use. can someone give me some advice on this?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Hydrogen Air combustion in a combustion chamber||popi||CFX||7||July 11, 2007 19:40|
|Need Similar Combustion Tutorial as my model||Arnab||CD-adapco||0||May 24, 2005 19:23|
|Multiresolution + Turbulence + Combustion||Raul||CD-adapco||0||March 18, 2005 08:56|
|Multiresolution + Turbulence + Combustion||Raul||CFX||0||March 18, 2005 08:53|
|Multiresolution + Turbulence + Combustion||Raul||Main CFD Forum||0||March 18, 2005 08:53|