|
[Sponsors] |
July 4, 2010, 14:01 |
MIcrochannels.
|
#1 |
New Member
|
I am simulating microchannels in FLUENT. I have a single channels with rectangular crosssection. Hydrolic diameter is 0.0015, Length is 1 cm.
BC: Inlet> Velocity inlet Outlet> Outflow Bottom wall > Heat flux: 100000 w/m2, Th:0.0005m Upper and side walls: Adiabatic, Th:0.0005m But What I get in pressure contour is negative pressure inside the channel which does not make any sense. Can I have your opinions on the issue please. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem simulating bubble formation in microchannels | iitian2005 | FLUENT | 0 | June 3, 2009 03:03 |
How to model H2 flow through microchannels? | Adarsh | Main CFD Forum | 3 | December 15, 2005 11:47 |
MR Fluid Flow through microchannels | Sinan | FLUENT | 0 | September 18, 2004 00:03 |
Two-phase flow in microchannels | Shubidu | Main CFD Forum | 0 | January 5, 2004 05:24 |
secondary flow in microchannels | uwe | Main CFD Forum | 1 | August 26, 2001 11:35 |