|
[Sponsors] |
September 3, 2010, 10:32 |
Volume Fraction & Velocity Magnitude
|
#1 |
New Member
|
Greeting to all CFD users,
I'm simulating a 3D system using FLUENT and currently facing problem in extracting certain data from it. Given the following: Volume: 0.1 m3 max velocity magnitude: 1.7 m/s Question: How can I ask FLUENT to generate the percentage of volume which has velocity magnitude of less than 5% of the maximum velocity? Thank you very much in advance for any suggestions and inputs. alven.. |
|
September 4, 2010, 02:30 |
|
#2 |
New Member
|
I have managed to figure it out. First...use the iso-value adaptation to mark the region of desired velocity magnitude. Then separate the marked zone in grid>separate>cells. Finally, use the report volume and select the newly separated zone.
alven |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Errno 24 linux | ivanwhlau | OpenFOAM Running, Solving & CFD | 6 | July 1, 2009 10:16 |
interDyMFoam - change in volume fraction | gopala | OpenFOAM Running, Solving & CFD | 0 | April 27, 2009 10:46 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
How to set volume fraction in two phase flow | Kamel | FLUENT | 2 | March 23, 2007 00:06 |
the Eulerian model and the lower volume fraction | hx li | FLUENT | 2 | October 27, 2005 06:17 |