|November 16, 2010, 01:19||
From Gmsh to Fluent
Join Date: Aug 2010
Location: El Paso Texas
Posts: 28Rep Power: 7
I created a 3D mesh on Gmsh, and i exported to Fluent, but Fluent gives me the following error:
-Under the boundary conditions for a wall under the Thermal tab, it is telling me that "This page is not applicable under current settings"
Basically what i'm trying to do is have a channel running through a block of metal (kind of like a heat exchanger). I created the geometry under Gmsh and imported to Fluent as a Nastran Bulk Data File. When i get to setting the boundary conditions is when i run into trouble.
i included the .geo file from gmsh and the .cas file from fluent... any help will be great... thanks.
P.S. I tried to upload the files but was unable to ... apparently they are too large even when compressed.
|February 23, 2012, 12:45||
Join Date: Oct 2010
Posts: 6Rep Power: 7
I believe your problem is that you have not specified the solver to solve the energy equation. In order for FLUENT to use thermal conditions you must toggle the energy equation.
turn "Energy" to On
Hope that helps
|Thread||Thread Starter||Forum||Replies||Last Post|
|Stopping a Fluent batch job AND saving the data! Possible?||Volker Pawlik||FLUENT||7||May 22, 2014 22:30|
|A Problem of Fluent Interpreted UDF: parse error||knight||Fluent UDF and Scheme Programming||11||December 8, 2013 10:00|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Compared MRFSimpleFoam and Fluent in a centrifugal pump!||renyun0511||OpenFOAM Running, Solving & CFD||8||July 6, 2010 06:24|
|Problems in lauching FLUENT||Lourival||FLUENT||3||January 16, 2008 17:48|