setting different convergence criteria

gubarrani · January 4, 2011, 02:26

hi everybody!!!

Convergence in my simulation case is obtained when Cm (moment coefficient) is uniformed. I wanted to do somehow a program to check the difference of Cm value in the last X iterations and see if it changed a lot or not in order to see convergence...

Shall I do it via UDF or scheme programming or is there any other way?? Do you know of any place where to have a look to know it better??

thanks...

-mAx- · January 4, 2011, 05:36

I have such a file (.scm), but very very few used
If you want it, give me your email via private message

January 4, 2011, 02:26	setting different convergence criteria	#1
gubarrani New Member osman Join Date: Jan 2011 Posts: 3 Rep Power: 15	hi everybody!!! Convergence in my simulation case is obtained when Cm (moment coefficient) is uniformed. I wanted to do somehow a program to check the difference of Cm value in the last X iterations and see if it changed a lot or not in order to see convergence... Shall I do it via UDF or scheme programming or is there any other way?? Do you know of any place where to have a look to know it better?? thanks...

January 4, 2011, 05:36		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	I have such a file (.scm), but very very few used If you want it, give me your email via private message __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58
What value shall I set for the Convergence criteria?	steventay	CFX	7	May 14, 2010 12:44
Setting Convergence criteria for "rhopSonicFoam" instead of end time	mecbe2002	OpenFOAM	2	March 7, 2010 04:24
Convergence Criteria	edwin	FLUENT	1	February 14, 2008 19:24
Warning 097-	AB	Siemens	6	November 15, 2004 04:41