|
[Sponsors] |
February 17, 2011, 06:20 |
determine the right settings
|
#1 |
New Member
Join Date: Feb 2011
Posts: 9
Rep Power: 15 |
how i decide the time step?
my 2d problem const of a beam section (0.3m x 0.3m ) invested by a flow at 15 m/s. the domain along x axle is from -5 to 10 m and and from -4 to 4 along y axle. i would like to investigate the oscillation of kolmogorov scale of vortex, so i made a mesh from 0.001 at the section to expand up to 0.150 at the boundary. i use a k-om sst unsteady model with a time step of 0.005, but the lift and drag plot are so bad.. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BC settings to expand pressure on atmosphere - simpleFoam / totalPressure | sErik | OpenFOAM Running, Solving & CFD | 1 | June 15, 2011 02:49 |
How to determine the location of the cell center | zmester | Main CFD Forum | 0 | October 11, 2009 06:58 |
determine wall-shear-stress | Joeblue | FLUENT | 2 | July 11, 2007 12:50 |
Default settings for 3D boundary layer-Gambit 2.2 | Ramine | FLUENT | 1 | July 31, 2006 12:36 |
help on memory settings in TASCflow | Dr C.Bhasker | CFX | 1 | September 5, 2001 05:57 |