|
[Sponsors] |
Membrane (Porous Zone) Simulation to separate CO2 from Flue Gas. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 3, 2019, 12:33 |
Membrane (Porous Zone) Simulation to separate CO2 from Flue Gas.
|
#1 |
New Member
Selangor Darul Ehsan
Join Date: Sep 2019
Posts: 1
Rep Power: 0 |
Can someone help me on how to setup my ansys fluent. I'm a student on final year doing a final year project.
So basically, I have done my geometry and meshing. I'm a bit lost on the setup section. I'm doing a simple 2D simulation. I tried but the result is quite disappointing. https://ibb.co/kGZb0fW |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
Porous zone input properties | chaudhry_hashim | FLUENT | 0 | September 10, 2014 02:48 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
[GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |