|
[Sponsors] |
May 27, 2011, 06:30 |
boundary condition
|
#1 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
Hello
Is it possible to change boundary condition during non steady state simulation, e.g. after 10 seconds of simulating changing the poutlet to wall, is it possible to do it regarding the case of satisfaction of some predefined criteria, e.g. if the domain reaches a specific amount of velocity... one can change from poutlet to wall , Thank you Hamid |
|
May 27, 2011, 12:22 |
|
#2 |
New Member
MadhuVC
Join Date: Feb 2011
Posts: 28
Rep Power: 15 |
you should be able to change it... depends on how are you running your transient simulation. i.e via a journal file, udf... you can change it via GUI too...
|
|
May 27, 2011, 12:43 |
|
#4 |
New Member
MadhuVC
Join Date: Feb 2011
Posts: 28
Rep Power: 15 |
journal file..
set your boundary conditions to say Pressure outlet run it for 10 secs write the file den set the boundary conditions to wall run it.. it should work...i have changed it using GUI..that works . hope this helps... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 05:05 |
Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 03:23 |
How exactly the "pressure outlet" bdry condition compute properties on the boundary? | yating9901 | FLUENT | 3 | June 28, 2010 12:26 |
How to set boundary condition in Fluent for the fo | Peiyong | FLUENT | 1 | November 10, 2006 11:44 |