 |
 |
 |
|
|
|
[Sponsors] | ||||
March 16, 2022, 10:04
|
ICEM is unable to trim the surface
|
#1 |
|
Member
Join Date: Aug 2018
Posts: 85
Rep Power: 7  |
Hi, I am trying to create the geometry of NACA0002 in ICEM CFD. However, while trimimng surface of NACA0002 from the outer domain is not responding. I have tried for a cylinder and NACA0012 it is working perfectly.
I did the following steps to create model. (i) Imported the data points of NACA0002 in ICEM CFD (ii) Joined those points and two curves are here as NACA0002 boundary surface (iii) created the outer domain of FVM. (IV) created surface of outer bounday (v) Try to make segment/trim of surface by selecting the surface first and then the curves of NACA0002. Here is nothing shown up. No trimmimng. Can anyone tell me why is this happening? Thank you! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] The ICEM Guide for CFX Users | JuPa | ANSYS Meshing & Geometry | 11 | September 4, 2017 09:43 |
| [snappyHexMesh] snappyHexMesh: unable to get mesh snapped to the surface where surface is curved | gupta29505 | OpenFOAM Meshing & Mesh Conversion | 1 | December 28, 2015 13:34 |
| ICEM Surface problem | error404 | ANSYS Meshing & Geometry | 6 | June 6, 2014 04:33 |
| [ICEM] ICEM CFD: STL surface mesh to volumetric mesh | a.sarami | ANSYS Meshing & Geometry | 0 | August 20, 2013 10:32 |
| ICEM Surface from points cloud ? | Guillaume | CFX | 1 | June 13, 2007 14:42 |
Linear Mode
