|October 29, 2011, 17:45||
suction pipe in reservoir
Join Date: Nov 2010
Posts: 7Rep Power: 7
I am new to fluent and also new here but I am glad to see CFD men here!
well, I am simulating flow in a suction pipe in a reservoir.
during the iteration these messages appear:
-reversed flow in 360 faces on pressure inlet
-turbulent viscosity limited to viscosity ratio of 1e+5 in 7156 faces.
the iteration converged for residuals 1e-3 but these messages didn't vanished! so what can I do to solve these problems?
it is good to say that the boundary condition for free surface has set to pressure inlet=0 and the boundary condition for the outlet(where the flow pours out from the pipe) has set to velocity inlet=-2
|Thread||Thread Starter||Forum||Replies||Last Post|
|[DesignModeler] DesignModeler Pipe within pipe||shields||ANSYS Meshing & Geometry||12||April 30, 2015 03:58|
|pipe in pipe heat exchanger||JohannV||FLUENT||3||December 3, 2009 03:53|
|My Revised "Time Vs Energy" Article For Review||Abhi||Main CFD Forum||2||July 9, 2002 09:08|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|