|
[Sponsors] |
December 8, 2011, 00:59 |
Changing BC type
|
#1 |
New Member
Apurv
Join Date: May 2011
Posts: 10
Rep Power: 15 |
Hi All,
Is it possible to change the boundary condition type (like wall, interior etc) during simulation? Can this be specified in the UDF? I intend to have different BC type for certain conditions during simulation. I would greatly appreciate any suggestions in this regard. Regards, Apurv |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
second order schemes | marine | OpenFOAM | 67 | April 11, 2022 18:19 |
boundary conditions for simpleFoam calculation | foam_noob | OpenFOAM Running, Solving & CFD | 8 | July 1, 2015 08:07 |
Need help with boundary conditions: open to atmosphere | Wolle | OpenFOAM | 2 | April 11, 2011 07:32 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 17:08 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |