|
[Sponsors] |
Simulate atomisation without using in built models |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 23, 2012, 01:35 |
Simulate atomisation without using in built models
|
#1 |
New Member
Join Date: Feb 2012
Posts: 18
Rep Power: 14 |
I would like to know if it is possible to study the effects of own nozzle design geometry on droplet size distribution, without using Fluent's atomisation model.
(i.e. import nozzle geometry mesh, set necessary BCs, and simulate the droplet distribution) Tried it before, but the resulting fluid don't seem to break up when they exit the nozzle. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thermophysical models and chemistry models | hk318i | OpenFOAM | 31 | April 6, 2012 10:53 |
Models for Erosion in Slurry Pipe | leonozx | FLUENT | 1 | May 25, 2011 10:28 |
Two-fluid models vs mixture models for bubbly flows | Hansong Tang | Main CFD Forum | 6 | December 8, 2009 03:21 |
possibles simulate 1D models | Mashihu | FLUENT | 4 | May 20, 2003 05:33 |
Reynolds Stress Models | Roued | Main CFD Forum | 20 | February 8, 2000 02:58 |