|
[Sponsors] |
March 26, 2012, 11:30 |
FLUENT negative volume
|
#1 |
Member
Join Date: Jun 2011
Posts: 48
Rep Power: 14 |
I have developed a fairly complex mesh in ANSA. When I do a mesh check in ANSA for negative volumes, it does not detect any. When I load the .msh file into fluent however, and do a mesh check there, it finds the minimum volume to be negative. Does anyone know if fluent can somehow display visually, or just spit out the xyz coordinates of where this negative volume is located so I can check it out in ANSA?
thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Negative cell volume detected, dynamic mesh | tony25800 | FLUENT | 6 | September 17, 2014 19:50 |
Negative Volume during Mesh Motion Analysis | giov_ingr | FLUENT | 2 | December 13, 2013 06:09 |
Dynamic meshing in CFX: (negative volume error) | vmlxb6 | CFX | 6 | August 28, 2010 06:43 |
blockMesh error ... | balkrishna | OpenFOAM Pre-Processing | 0 | August 17, 2010 02:39 |
Negative volume in mesh motion | skarp | CFX | 5 | July 11, 2007 23:51 |