|
[Sponsors] |
July 2, 2012, 10:27 |
SolidWorks Flow Simulation Probem
|
#1 |
New Member
rajhans
Join Date: Jul 2012
Posts: 1
Rep Power: 0 |
Problem Description:
I have a set of nozzles in a unit with a coil on the side. I have problem in defining the boundary conditions for the coil in the software, if someone can help me out with this, I will really appreciate it. The basic diagram is attached wit the thread. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is Solidworks Flow Simulation Good? | corriolisforce | Main CFD Forum | 4 | October 22, 2018 11:44 |
Domain format problem on airfoil flow simulation | andrenonaka | CFX | 14 | December 7, 2015 00:42 |
Comparison between Solidworks Flow Simulation and Ansys Fluent | Bruce828 | Main CFD Forum | 5 | February 23, 2013 10:13 |
Blockage in pipe ( using solidwork flow simulation) | jchow | FloEFD, FloWorks & FloTHERM | 1 | January 16, 2012 16:03 |
SolidWorks Flow Simulation | Koranten | Main CFD Forum | 5 | October 29, 2010 11:24 |