|April 2, 2013, 10:07||
basic about turbulance modeling
Join Date: Jan 2013
Location: Rajkot, India
Posts: 36Rep Power: 4
I want to use turbulent models but dnt know which to use n also I don't the differences among the models.
so can u plz explain
what is RANS approach?
what is SAS approach?
I want to know actually what is basic differences among above model?
Is grid generation (meshing ) affects the selection of model of turbulence?
please reply as early as possible....
thanks in advaanve
|April 2, 2013, 10:21||
Join Date: Jun 2011
Posts: 1,274Rep Power: 18
You should just read any good book about CFD. These questions are much too extensive for a forum. I doubt anyone will help you satisfactorily with that.
The skeleton ran out of shampoo in the shower.
|April 2, 2013, 10:37||
Filippo Maria Denaro
Join Date: Jul 2010
Posts: 1,859Rep Power: 25
|Thread||Thread Starter||Forum||Replies||Last Post|
|Combustion Modeling with COMSOL||davidst||Main CFD Forum||0||January 11, 2013 13:39|
|Modeling both turbulance and laminar flow in one||MDG||FLUENT||0||October 31, 2006 17:45|
|May Focus Area: Turbulence Modeling||Jonas Larsson||CFD-Wiki||0||May 2, 2006 11:48|
|Modeling Flow/Saturation/Absorption in Fibers||Gene Dougherty||Main CFD Forum||0||June 6, 2003 14:49|
|CFD Modeling of Two-phase Flow in Small Dia.Tubes||Eric Poindexter||Main CFD Forum||2||September 22, 2000 09:21|